Tunturi J4F, J5F owner manual Handrails

defined as seen from the exercising position. To avoid injury, you must fold up the deck prior to lifting the treadmill out of the box.

HANDRAILS

Connect the wires before you assemble the handrails. Secure each handrail with four washers and bolts. NOTE: Do not tighten these bolts until the horizontal handlebar and monitor have been secured.

HORIZONTAL HANDLEBAR

The horizontal handlebar (rod) is tapered on one side. Insert the tapered end of the rod into the right handrail before fitting the rod into the left side. NOTE: the left side is secured with the long bolt while the right ride is secured with the short bolt. Do not tighten these bolts until the monitor has been secured.

MONITOR

Connect the wire. After connecting the wire thread it into the handlebar then push the monitor onto the handrails. You may have to shake the handrails from side to side to get the monitor to fit. Once you have the monitor in place, secure and tighten the bolts on the monitor. Tighten all bolts. Remove the protective film from the display.

POWER CORD AND GROUNDING

INSTRUCTIONS

Plug the socket end of the power cord into the treadmill at the left front corner. Before connecting

O W N E R ' S M A N U A L • J 4 F / J 5 F

the device to a power source, make sure that local voltage matches that indicated on the type plate. The treadmill operates at 230 V or 120 V. Turn on the power using the switch next to the socket on the treadmill. This treadmill must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electrical current to reduce the risk of electrical shock. This product is equipped with a cord having an equipment-grounded conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not use extension cables when connecting the equipment to the power source.

DANGER! Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman, if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

If the product is for use on a nominal 120-volt circuit, it has a grounding plug that looks like the plug illustrated. Make sure that the product is connected to an outlet having the same configuration as the plug. No adapter should be used with this product.

SAFETY TETHER KEY

The treadmill cannot be used if the tether key is not properly installed on the meter; if the key is removed from its place, the treadmill will immediately stop. Insert the safety tether key into the key holder at the left side of the meter. Ensure that the clip of the safety tether key is properly attached to your clothing; as the cord tightens, make sure the clip does not detach itself from your clothing before the safety tether key disconnects from the user interface. Always hold the handrail for support when getting off the treadmill. Do not jump off the running belt while it is moving!

G B

3