Turbo Air MSR-72G-3 Cleaning The Condenser Fins, Clean The Gasket, Check After Cleaning

CLEANING

1.CLEANING STAINLESS STEEL INTERIOR AND EXTERIOR (select models)

:Damage to stainless steel finish due to improper use of cleaning products or non- recommended products is NOT covered under this product's warranty.

•DO NOT USE

- Abrasive or harsh cleaners - Ammonia

- Chlorine bleach

- Concentrated detergents or solvents

- Metal or plastic-textured scouring pads - Vinegar-based products

- Citrus-based cleaners

•Do

- Use warm, soapy water and a soft, clean cloth or sponge.

- Rinse surfaces with clean, warm water and dry immediately to avoid water spots.

2.CLEANING THE CONDENSER FINS

-To maintain proper refrigeration performance, the Condenser coil must be free of dust, dirt, and grease.

This will require periodic cleaning. Condenser fins should be cleaned at least every three months (90 days) or as needed.

3.CLEAN THE GASKET

-The door gasket should be cleaned frequently to maintain proper sealing.

4.CHECK AFTER CLEANING

-Check the unit again for safety.

-Check that the unit is operating properly.

CAUTION

1.POWER CORD

-Be sure that the power cord is connected to the proper voltage.

-A protected circuit of the correct voltage and amperage must be run for connection of the line cord.

-Turn ‘off’ the power switch before disconnecting the power cord, whenever performing maintenance functions or cleaning the refrigerated cabinet.

-Compressor warranties are void if compressor burns out due to low voltage.

2.RE-STARTING

-If disconnected, wait for 5 minutes before re-starting.

4

Turbo air