user manual
MILAN
Connecting to the Milan MI5
1. Mains Connector and Fuseholder
Mains power is connected to the loudspeaker via a combination IEC connector and fuseholder. The power supply is
6 7 8 9
BASS | TREBLE MIX OUT |
0 | 0 |
LIMIT
BASS
MODE
change any settings.
A B
_+ _+
POWER
LEVEL | INPUT 1 | INPUT 2 | LEVEL |
2. Mains Switch | 5 | 5 |
|
Rocker switch turns mains power on to the loudspeaker. Make sure the level controls are fully off (MIN) before switching on.
3. Signal Input
These combo female XLR/jack connectors accept both XLR connectors and mono (2 pole) or stereo (3 pole) ¼” jack plugs for use with a variety of balanced and unbalanced microphones, instruments and line sources. The inputs are balanced to avoid hum loops and RF interference, and are wired pin 2 hot, pin 3 cold.
MIN | MAX | MIN | MAX |
MIC | LINE | LINE | MIC |
4 3 3 4
4. Mic / Line Switch
Selects the input for that channel to accept either a low level, low impedance microphone, or a high level, high impedance source such as a mixing console, keyboard or acoustic instrument with onboard electrics. The mic input is not suitable for condenser microphones that require phantom power.
5. Level Control
Rotary level control which attenuates the input signal level of |
|
the connected instrument / line source for that input channel. |
|
The range (mic) is from |
|
from | 1 |
6. Bass Control and 7. Treble control
The bass control provides ±12dB of shelving at 200Hz, and the treble control provides ±12dB of shelving at 4kHz. Always use equalisation sparingly, aiming to cut rather than boost especially when the loudspeaker is used near boundaries such as walls or floors.
POWER
ON
FUSE T10AL
REPLACE ON LY WITH SAME
TYPE AND R ATING OF FUSE
2
MILAN user manual Page 13