Turbosound MI5 Getting Started, Milan, user manual

Models: MI5

1 28
Download 28 pages 7.91 Kb
Page 7
Image 7
Getting Started

user manual

MILAN

Getting Started

BASS

TREBLE MIX OUT

0

0

_Manual backgroundManual background+ _Manual backgroundManual background+

LEVEL

INPUT 1

INPUT 2

LIMIT

BASS

MODE

A B

-6dB

POWER

LEVEL

MIN

MAX

MIN

MAX

MIC

LINE

LINE

MIC

1.Turn the level controls fully anticlockwise (MIN) on both input channels.

2.Set the Bass and Treble tone controls to their centre position (no boost or cut).

3.Connect your signal sources (mixing console, keyboard, microphone, acoustic guitar) to the input connectors and select MIC or LINE as appropriate for that source.

4.If the loudspeaker is to be used as a floor monitor, or for use with subwoofers, set the BASS MODE switch to the ‘B’ position; otherwise select the ‘A’ position.

5.Switch on the mixer or other source and make sure the output faders or master output level controls are turned fully down.

6.Connect the AC mains cable to the Milan loudspeaker and turn on the mains switch. The blue POWER LED will illuminate to indicate that mains power is connected.

7.Increase the output level of the signal source to a normal operating level.

8.Slowly turn up the Milan loudspeaker’s level control(s) until a suitable volume level is reached. The green SIGNAL LED illuminates when the input signal is -6dB from limiting. It is normal for the LIMIT LED to flash occasionally, but excessive or prolonged illumination indicates that the input signal is too high or additional speakers are required.

9.When shutting down the Milan system, first turn down the input level controls, then switch off the mains power before turning off the mixer or signal source.

MILAN user manual

Page 7

Page 7
Image 7
Turbosound MI5 Getting Started, Milan, user manual