Tyco Electronics P7100IP 8.3 ALERT TONES

MM101332V1, Rev. K

MESSAGE NAME DESCRIPTION

SYSC OFF System Scan

Features Off Trunked mode only. Indicates the System Scan

features are disabled.

LOW BATT Low Battery Battery voltage has dropped to the p oint to where the

radio is no longer able to transmit. The radio will still

receive calls until the battery is discharged beyond

the point of operation at which time the radio will

automatically shutdown.

Trunked and P25 modes only. Indicates an

emergency call is being received. This message will

be flashing on line two.

Receive

Emergency

RXEMER

Trunked and P25 modes only. Indicates an

emergency call has been transmitted on this radio.

This message will be flashing on line two.

Transmit

Emergency

TXEMER

Volume Level Indicates the current volume level. The volume level

display ranges from OFF (silent) to 31 (loudest).

VOL=31

WHC Who Has

Called Trunked and P25 modes only. Indicates an

individual call has been received, but not responded

to. The indicator turns OFF if the individual call mode

is entered, the system is changed, or the radio is

turned off and then on again.

UNKNOWN Unknown ID Trunked and P25 modes only. Indicates an

individual call is being received from an unknown ID.

8.2.4 Error Messages

If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs

servicing.

DSP ERR

ERR=XXXX

(PowerUp only)

or DIG V x

ERR x

Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.

8.3 ALERT TONES

The P7100IP radio provides audible Alert Tones or “beeps” to indicate the various operating conditions

(see Table 8-2).

27

Contents

Main MM101332V1, Rev. K MANUAL REVISION HISTORY 2 Page Page Page Page 1 SAFETY TRAINING INFORMATION 1.1 RF EXPOSURE GUIDELINES 1.2 ELECTROMAGNETIC INTERFACE/COMPATIBILITY 2 SAFETY SYMBOL CONVENTIONS MM101332V1, Rev. K 3 OPERATING TIPS 3.1 EFFICIENT RADIO OPERATION 3.1.1 Antenna Care and Replacement MM101332V1, Rev. K 3.1.2 Electronic Devices 3.1.3 Aircraft 3.1.4 Electric Blasting Caps 3.1.5 Potentially Explosive Atmospheres 4 MARITIME CHANNELS MM101332V1, Rev. K 5 BATTERIES 5.1 CONDITIONING NIMH BATTERY PACKS 5.2 CONDITIONING NICD BATTERY PACKS 5.3 ADDITIONAL INFORMATION 5.4 CHANGING THE BATTERY PACK 5.5 BATTERY DISPOSAL 6 INTRODUCTION 6.1 WATER RESISTANCE 7 OPTIONS AND ACCESSORIES DESCRIPTION PART NUMBER Page Page MM101332V1, Rev. K 8.1 CONTROLS 8.1.1 Buttons and Knobs MM101332V1, Rev. K 8.1.2 Keypad (Scan and System Models Only) Primary Function: Accesses the pre-stored menu. The Figure 8-5: Scan Radio Front Panel Page MM101332V1, Rev. K 8.2 DISPLAY 8.2.1 Radio Status Icons Table 8-1: Display Descriptions MM101332V1, Rev. K 8.2.2 Tri-Color LED 8.2.3 Status Messages MM101332V1, Rev. K MESSAGE NAME DESCRIPTION 8.3 ALERT TONES 8.4 UNIVERSAL DEVICE CONNECTOR (UDC) 9 CONVENTIONAL OPERATION 9.1 RECEIVING A CALL 9.2 SENDING A CALL MM101332V1, Rev. K 10 BASIC OPERATION 10.1 TURNING ON THE RADIO 10.2 SYSTEM SELECTION 10.3 GROUP/CHANNEL SELECTION or to scroll through the group list. The display registers the new group Page Page Page Page Table 10-1: Menu Item Information MM101332V1, Rev. K 10.12 DIGITAL VOICE OPERATION 10.12.1 Clear Mode 10.12.2 Digital Mode MM101332V1, Rev. K 10.12.3 Private Mode MM101332V1, Rev. K 10.12.4 Private Operation Page 11 TRUNKED OPERATION Page MM101332V1, Rev. K 11.1.3 Deleting Groups from a Scan List 11.2 SCANNING TRUNKED SYSTEMS 11.2.1 Wide Area System Scanning Page MM101332V1, Rev. K 11.3 EMERGENCY OPERATION 11.3.1 Receiving an Emergency Call 11.3.2 Declaring an Emergency Call 11.4 INDIVIDUAL CALLS 11.4.1 Receiving and Responding to an Individual Call (Trunked Mode Only) Page Page Page MM101332V1, Rev. K 11.5.3 Dual-Tone Multi-Frequency: Overdial/Conventional Mode Page MM101332V1, Rev. K 11.7 STATUS/MESSAGE OPERATION 11.7.1 Status Operation 11.7.2 Message Operation 11.7.3 Dynamic Regroup Operation REGRP_0x 11.8 PORTABLE DATA 11.8.1 Displays 11.8.2 DATA OFF Operation 11.8.3 DATA ON Operation MM101332V1, Rev. K 11.9 PAGE (P25 TRUNKING ONLY) Page MM101332V1, Rev. K 12 PROJECT 25 (P25) CONVENTIONAL OPERATION 12.1 GROUP CALLS IN P25 MODE 12.1.1 Transmitting a Group Call 12.1.2 Receiving a Group Call 12.2 INDIVIDUAL CALLS IN P25 MODE 12.3 EMERGENCY GROUP CALLS IN P25 MODE 12.3.1 Declaring an Emergency Group Call 12.3.2 Receiving an Emergency Group Call 13 RADIO TEXTLINK OPERATION (EDACS ONLY) 14 OPERATION FOLLOWING WATER CONTACT 14.1 RADIO MICROPHONE 14.2 RADIO SPEAKER 15 IMMERSIBLE P7100IP PREVENTIVE MAINTENANCE 15.1 TECHNICAL ASSISTANCE IMMERSIBLE P7100 16 BATTERY WARRANTY 17 WARRANTY