TLM, TLF, TLD
CLEANING AND SANITATION
Component Removal and Installation Instructions for Cleaning
Lower Trays and Screens
1.Open the front straight glass by lifting the handle at the bottom.
2.Remove product from the case interior.
3.Grasp and lift out each lower tray or screen from the bottom of the case.
4.After cleaning, replace in reverse order.
Front Air Ducts
1.Remove lower trays or screens, see this page.
2.Lift out front air duct sections.
3.After cleaning, replace in reverse order.
Rear Air Ducts
1.Remove lower trays or screens, see this page.
2.Remove mounting screws from rear air duct.
3.Lift out rear air duct sections.
4.After cleaning, replace in reverse order.
Mullion Covers
1.Open the front straight glass by lifting the handle at the bottom.
2.Remove mounting screws from each mullion cover.
WARNING
Mullion covers with electrical receptacles can be cleaned without removing the electrical receptacles. Do not get moisture on electrical wires when cleaning under this cover. Moisture on wires could cause premature product failure and/or personal injury or death from electrical shock.
3.Carefully remove each mullion cover from the rear uprights.
4.After cleaning, replace and secure mullion covers in reverse order.
End Coil Cover (TLM/TLF)
1.Open rear sliding doors at each end.
2.Remove screws and end coil covers from ends of upper coil.
3.After cleaning, replace end coil covers in reverse order.
Refrigeration Line Cover (TLM Only)
1.Open the front straight glass by lifting the handle at the bottom.
2.Remove lower screens, see this page.
3.Remove mounting screws and refrigeration line cover.
4.After cleaning, replace in reverse order.
Electrical Cover (TLM Only)
1.Open the front straight glass by lifting the handle at the bottom.
2.Remove lower screens, see this page.
3.Remove mounting screws and electrical cover.
WARNING
Do not get moisture on electrical wires when cleaning under this cover. Moisture on wires could cause premature product failure and/or personal injury or death from electrical shock.
4. After cleaning, replace in reverse order.
Front Lower Cladding
1.Remove front kickplate.
2.Lift and pull out front lower cladding until rear tabs clear holes in front of frame assembly. After rear tabs are clear, pull down on cladding to clear upper tabs from slots in bottom of upper front cladding and remove cladding from case.
3.After cleaning, replace front lower cladding by inserting top tabs, then rear tabs. Make sure all tabs are securely fit in each slot. Replace front kickplate.
Front Upper Cladding
1.Remove color band, bumper and bumper retainer from the case. See page 31.
Page 22 | April, 2007 |
