Installation & Service Manual | TLM, TLF, TLD |
6.Note position of old heater wire and foil tape. Unpug heater wire from harness connector and remove foil tape and heater wire. Install new heater wire and foil tape in same position as removed.
7.
8.Reinstall front cladding, bumper components and color band in reverse order.
Front Glass Anti-Fog Fan Replacement
1.Lift and tlit out the lower front cladding to remove from front of case.
NOTE
The bottom of the front upper cladding may have to be pulled out slightly to access the top fan mounting screws.
2.Disconnect defogger fan power cord.
3.Remove four screws and defective fan from fan brackets.
4.Install new defogger fan on fan brackets and secure with four screws. Reconnect the defogger fan power cord.
5.Reinstall the lower front cladding.
Lift-Glass Replacement
WARNING
Wear safety glasses and gloves and use at least two people when replacing glass. Glass is heavy and weight distribution is uneven. Mishandling of glass could cause breakage and/or personal injury.
If replacing glass:
1. Raise the old glass to the full UP position.
NOTE
Glass is heavy and requires assistance for properly support.
2.With assistants firmly holding both ends of the glass, loosen the set screws on the bottom of each hinge with an allen wrench. After set screws are loosened, slide old glass assembly to right or left to remove from hinges.
September, 2004 | Page 29 |
