Installation & Service Manual | TLM, TLF, TLD |
Grease and oil | Organic solvents such as |
| carbon tetrachloride, tri- |
| chlorethylene, acetone, kero- |
| sene, gasoline, benzene, |
| alcohol and chlorethane n.u. |
Rub with a cloth. Organic solvents may be flammable and/or toxic. Observe all precautions against fire. Do not smoke while vapors are present. Be sure area is well ventilated.
Satisfactory for use on all finishes.
*Use of proprietary names is intended only to indicate a type of cleaner, and does not constitute an endorsement, nor is omission of any proprietary cleanser to imply its inadequacy. It should be emphasized that all products should be used in strict accordance with instructions on package.
**In all applications a sponge or fibrous brush or pad are recommended. DO NOT use ordinary steel wool, steel brushes, chlorine bleach or products containing bleach for cleaning or sanitizing stainless steel.
GENERAL INFORMATION
Rear Sliding Door Removal and Installation
The sliding doors come installed from the factory in the door frames. These doors are removable for cleaning and to aid in case maintenance. NOTE: DO NOT FULLY IMMERSE DOORS WHEN CLEANING. The inner and outer doors are marked with labels from the factory. If the doors are not labeled, the inner door can be identified as having the limiter stops on it.
1.Remove the outer door (1) by sliding it to the right end of the door frame (2) (within an inch of being closed).
2.Firmly grasp both sides of the outer door
(1) and lift into the upper track (3) until it clears the lower track (4).
3.Tilt out the bottom of the outer door (1) so it can clear the lower track (4).
4.Lower the outer door (1) out of the upper track (3) to remove it from the case.
5.Repeat steps 1 thru 4 to remove the inner door (5).
6.Reverse the above steps to replace the inner and outer doors (5 and 1).
April, 2007 | Page 25 |
