U-Line 2175DWRR manual Initial Startup, Interior Lighting, Electronic Control Panel, Operation

5 Operation

ULIN_0080_A

Figure 2

IMPORTANT

Proper air flow is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected (Figure 2).

Initial Startup

All U-Line units are shipped with controls that are preset. No initial adjustments are required.

IMPORTANT

U-Line recommends the unit be allowed to run overnight prior to loading the refrigerator with product.

NOTE: Control display is located inside top drawer.

1 2 3 4 5

ULIN_0058_A

Figure 3

To turn the unit on or off, touch and hold the POWER icon (Figure 3, 1) on the display panel for approximately ten seconds until the °F symbol flashes and release.

•A small LED above the icon will illuminate to confirm the touch of any controller icon.

•The display (Figure 3, 3) will show the unit set-point temperature (38°F) when the unit is on and will show OFF when the unit is off.

•Turning the unit off will override any other control function.

Interior Lighting

The interior drawer lights are controlled by individual switches on each drawer. As a drawer is opened, the light will go “ON.” The light will go “OFF” when the drawer is closed.

The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional lighting function. The blackout/ Sabbath mode (not Star K certified) will turn the interior lights and display (Figure 3, 3) off for a preset 36-hour period.

To access the blackout/Sabbath mode (not Star K certified):

1.Touch and hold the LIGHT icon (Figure 3, 5) for ten seconds and release (the °F symbol will flash briefly at the end of the ten second period).

2.The interior light and control display (Figure 3, 3) will go dark for the next 36 hours.

NOTE: Although the display will not be visible, the temperature controls in the unit remain active and the interior temperature will be maintained.

3.To exit the blackout/Sabbath mode (not Star K certified) manually at any time, repeat Step 1.

Electronic Control Panel

1 2 3 4 5

ULIN_0058_A

Figure 4

The electronic control with digital display (Figure 4) is configured to show a single temperature continuously. This set-point temperature is a base number used by the controller to maintain the temperature zone in your unit. The factory default set-point is 38°F. This set-point temperature is used as a gauge if further temperature adjustments are required.

Temperature Display Selection

U-Line products supplied for 110 VAC operation have temperatures displayed in a default Fahrenheit (°F) configuration (Figure 4, 3). Models supplied for 220 VAC operation have temperatures displayed in a default Celsius (°C) configuration.

The display can easily be adjusted for either type of temperature display. Press and hold the LIGHT icon (Figure 4, 5) and within five seconds press the COOLER icon (Figure 4, 4) three times to change the display as desired.

2175DWRR 7