Door Alignment Check and Adjustment
IMPORTANT
When properly aligned:
•The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top.
•The door gasket will be firmly in contact with the perimeter of the cabinet and not pinched on the hinge side of the door.
The following procedure will correct for up to 1/4 in. misalignment:
1/8" |
(3.175 mm) |
ULIN_0016_A |
Figure 14
1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet (Figure 14) and note the type (up or down) of adjustment needed.
ULIN_0133_A |
Figure 15
2.Remove the top hinge pivot pin with a Phillips screwdriver (Figure 15) and lift door off bottom hinge pin. Be careful not to lose the door closer insert sets.
| 1 |
2 | 3 |
| ULIN_0007_A |
Figure 16
3.Turn the door upside down and inspect the hinge plate mounting holes.
•Your plate has slotted mounting holes (Figure 16, 1). Loosen but do not remove the two hinge plate screws.
4.If door edge opposite the hinges needs to move up, move plate toward outside of door (Figure 16, 2). If door edge needs to move down, move plate toward inside of door (Figure 16, 3). Repeat until top edge of door is parallel with top of cabinet and tighten screws securely (Figure 16, 1).
1
ULIN_0004_A
Figure 17
5.After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers. Be sure that bosses on closers (Figure 17, 1) align with holes in the door and bottom cabinet hinge plates. Mount door and install top hinge pivot pin.
2115WC and 2115WCOL, 2175WC and 2175WCOL | 15 |
