5.Remove the two door closer inserts (Figure 22, 1) from the existing bottom hinge and install as shown on the new bottom hinge (Figure 21, 1).

6.Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin.

7.Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.

ULIN_0274_A

Figure 23

8.With bottom of door facing up, remove pivot plate (two screws), flip over, and remount on opposite side of door (Figure 23). Be sure slanted side of plate faces center.

9.Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin/closer inserts (Figure 21, 1).

10.Tilt top of door into position in top hinge and install top hinge screw pin.

11.Install plastic screw plugs removed in Step 2 in old hinge holes (three each, top and bottom).

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 24

1.Grasp the edges of the light housing lens

(Figure 24, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 24, 2).

2.Pull the edge of the lens down (Figure 24, 1) and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and will compromise the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

2115WC and 2115WCOL, 2175WC and 2175WCOL

17

Page 17
Image 17
U-Line 2115WCOL, 2175WCOL manual Light Bulb Replacement