75R, 75WC and 75BEV Models
5 Adjust Door
Checking Door Alignment
The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation.
IMPORTANT
Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way around the door (no gaps).
1.Carefully examine the door's gasket to assure that it is firmly in contact with the cabinet.
Note: When inspecting door alignment, make sure the light switch bracket makes contact with the light switch plunger. Also make sure the door gasket is not pinched on the hinge side of the door.
2.If the door is properly aligned, go on to 6 Prepare Power Supply. If it is not, use the following procedure.
Adjusting Door Alignment
75R, 75WC and 75BEV Units
1. | Loosen (do not remove) |
|
| top and bottom hinge |
|
| screws. See Figure 17. |
|
2. | Align door squarely with |
|
| cabinet. Make sure gasket |
|
| is firmly in contact with |
|
| cabinet all the way around |
|
| the door (no gaps). |
|
3. | Tighten bottom hinge | Figure 17 |
| screws. |
4.Tighten top hinge screws. Go on to 6 Prepare Power Supply.
6 Prepare Power Supply
Electrical Specifications
CAUTION
Electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician.
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended. GFCI (ground fault circuit interrupter) is usually not required for fixed location appliances and is not recommended for your unit because a GFCI could be prone to nuisance tripping. However, be sure to consult your local codes.
See Figure 18 for recommended receptacle location.
7" |
4" |
Figure 18 |
WARNING
SHOCK HAZARD — Electrical Grounding Required.
•Never remove the round grounding prong from the plug and never use a
•Never use an extension cord to connect power to the unit.
Go on to 7 Level the Unit.
10 | 02/2005 |
