75R, 75WC and 75BEV Models
Stainless 75R Units and All 75WC Units
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing. See Page 11.
Stainless 75R Refrigerator models and Black and Stainless 75WC Wine Captain models are reversible by moving the hinge hardware to the opposite side (Figure 11) as follows:
1.Remove the bottom hinge (two screws) from door.
2.Remove top hinge (two screws) from door.
3. Remove door.
4. Remove top hinge (four screws for 75R or three screws for 75WC) from
cabinet. Invert and install on bottom, opposite side of cabinet.
5.Remove bottom hinge (four screws for 75R or three screws for 75WC) from cabinet. Invert and install on top, opposite side of cabinet.
6.Attach top hinge to door.
7.Attach botton hinge to door.
8.Adjust door to assure proper seal.
Other Site Requirements
Power Supply
The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 10.
Environmental Requirements
The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (40°C). Units may be installed outdoors in a covered area. The unit must not be located near
Side-By-Side Installation
Instructions
For a complete refreshment center, install two of the following 75 series units side by side: 75R, 75WC and CO75 Combo Ice Maker/Refrigerator. Note that each
•
For example:
Placing a 75R next to another 75 series unit would require a
•No trim kit is required. However,
•Units must operate from separate, properly grounded electrical receptacles placed according to each unit’s Electrical Specifications.
Typical |
to |
7" |
4" |
1/4" Space |
Between |
Appliances |
Figure 12 |
02/2005 | 7 |
