Install the insert as follows:
!WARNING
Insert edges may be SHARP! Use care when installing.
1.Remove top hinge screw pin (7/64" Allen wrench, Figure 24). Remove door by tilting forward and lifting off bottom hinge pin.
2.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, mov- ing toward the edge (Figure 25). This may take some force. Do not remove the three screws behind gasket.
3.Remove two outside screws holding door handle. Slightly sep- arate door handle from door (Figure 26).
4.Pull handle up and off. Remove outer door panel and cardboard
spacer.
5.Slide custom door panel insert into 1/4 inch channel in door front.
6.Holding door gasket out of the way, replace handle on door making sure it is seated properly on insert and that screw holes line up.
7.Install two small screws removed in step 3.
8.Starting at the corners and working inward, push door gasket into place on door.
9.Place door on bottom hinge pin and install upper hinge screw.
Figure 24
Figure 25
Figure 26
UL310
DWR020
UL132
21