Ultra electronic Sicura Laminator quick start Adjusting the Hopper

Quick Start Guide Ultra Electronics Card Systems

J Adjusting the Hopper

The Card Feed Hopper has been factory set for use with 30 thou cards. Should it require adjustment, carry out the following procedure:

Remove the hopper from the laminator, remove the interface cable.

Insert a stack of your normal cards to be laminated. Cards should be flat for correct feeding.

View the cards edge-on at the card exit aperture and adjust the shutter screw so that 1½ cards thicknesses are exposed.

Re-fit the Card Feed Hopper and the cable.

Check for correction operation.

Page 18 MAGICARD Sicura Laminator