ADDITIONAL INFORMATION [ 53 ]
ADDITIONAL
INFORMATION
Troubleshooting

If your phone is not performing to your expectations, please try these simple steps f irst.

SSyymmppttoomm
The

ssttaattuuss

LED won´t light
when the handset is placed
in the base unit.
The audio sounds weak
and/or scratchy.
Can´t make or receive calls.
The handset doesn´t ring
or receive a page.
The Caller ID/CIDCW does
not display.
SSuuggggeessttiioonn
• Make sure the AC adapter is plugged into the base unit and wall outlet.
• Make sure the handset is properly seated in the base unit.
• Make sure the charging contacts on the handset and base unit are clean.
• Press during a call to help eliminate background noise.
• Make sure that the base unit antenna is in a vertical position.
• Move the handset and/or base unit to a different location away from metal
objects or appliances and try again.
• Make sure that you are not t oo far from the base.
• Check both ends of the base unit telephone line cord.
• Make sure the AC adapter is plugged into the base unit and wall outlet.
• Disconnect the AC adapter for a few minutes, then reconnect it.
• Reset the digital security code (See page 49).
• Make sure is pressed.
• The battery pack may be weak. Charge the battery on the base unit f or
15-20 hours.
• The handset may be too far away from the base unit.
• Place the base unit away from appliances or metal objects.
• Reset the digital security code (See page 49).
• Make sure that Ringer Volume is not set to Ringer Off.
• The handset was picked up before the second ring.
• The call was placed through a switch board.
• Call your local telephone company to verify your Caller ID service is current.
• Charge the handset.
• Make sure that “ CIDCW“ is not set to “ Off“.
UC772EZ ENG(24-148) 10/9/01 15:28 Page 53