Charging Spare Battery Packs
The Charger Unit of your ANA 9710 is equipped to charge the Spare Battery Pack with or without the Handset in the front slot.
1.Slide the Spare Battery Pack into the second slot in the Charging Unit until the retaining clip snaps over the top of the pack.
2.Make sure the BATT
CHARGE indicator lights. If the BATT CHARGE indicator doesn’t light, check to see that the AC Adapter is plugged in, and that the Battery Pack is making good contact with the Charging Unit charging contacts.
Note: Charge the Battery Pack without interruption for
3.When charging is complete, press out on the latch and remove the Battery Pack for use. Or, if you don’t need the Battery pack immediately, leave it in the Charging Compartment; it will not overcharge.
Low Battery Indicator
When the Battery Pack in the Handset is low and needs to be charged, you will see a message on the display.
On a Call | In Standby Mode |
|
|
|
|
All keys and functions are available. | None of the buttons operate. |
|
|
Handset beeps once every 3 seconds | Handset beeps every 15 seconds for 3 |
| minutes. |
|
|
Complete your call as quickly as | Cannot make or receive a call. |
possible |
|
|
|
Replace Battery pack within 20 | Replace Battery Pack before making a |
seconds to continue call. | call. |
|
|
Return the Handset to the Charging Unit for charging or replace the Handset Battery Pack with another charged Battery Pack.
20
