Uniden D1789 Getting Started, Set Up the Base, English, Attach the Stand, To Remove the Stand

Getting Started

Set Up the Base

Attach the Stand

Before you attach the stand, you have to decide if you want the phone to rest on a desk or hang

on a wall.

For desktop use

1. Turn the stand so the word Desk is right-side up (it will be on the left).

2. Insert the tabs into the notches marked Desk at the		DESK
	DESK	WALL

top of the base.

WALL

3.Slide the stand up until it snaps into place.

For wall mount use

1.Turn the stand so the word Wall is right-side up (it will be on the left).

2.Insert the tabs into the notches marked Wall at the bottom of the base.

3.Slide the stand down until it snaps into place.

To Remove the Stand

DESK

WALL

WALL

DESK

Pull the locking tabs up and back. Then, slide the stand straight off the opposite direction you put it on.

Connect the Corded Handset

Use the coiled cord to connect the corded handset to the connector on the left side of the base.

For wall mount use only

1. On the front of the base, pull the clip (that holds the corded handset in place) out of its slot.

2. Rotate the clip 180 degrees.

3. Flip it from front to back and slide it back into the slot.

Connect the Power and Telephone Cords

1.Connect the base AC adapter to the AC IN 7.8V jack and the telephone cord to the TEL LINE jack. Route the cords as shown.

English - 3