Bluetooth problems | Possible solutions | |
The D1789 doesn’t | xx Making sure your cellular phone has Bluetooth turned on. | |
xx Making sure your cellular phone is in range of the base. | ||
ring when my | ||
xx Making sure the station’s ringer is not turned off. (The base doesn’t | ||
cellular phone does. | ||
ring on cellular calls.) | ||
| ||
The D1789 paired | xx Adjusting the volume. | |
xx Setting your cellular phone to transfer the audio to a Bluetooth | ||
with my phone, but | device. Check your phone’s manual for instructions on Bluetooth | |
I can’t hear anything | setup and options. | |
through the station. | xx Erase the Bluetooth pairing and repair the cellular phone to the | |
| base. To erase the Bluetooth pairing, see page 14. |
Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone line from causing interference on your phone. To get a line filter, contact your service provider or look in an electronics store. Plug the filter into the telephone wall jack and plug the base into the filter. Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter & phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and use as normal. If you can hear liquid inside the housing:
1.Remove all compartment covers, and disconnect all cables and cords.
2.If liquid is leaking from any vent or hole, turn the phone so that the vent faces down. If not, place the largest vent face down.
3.Let dry for at least 3 days. Check for liquid inside the phone before replacing compartment covers & reconnecting cords.
Resetting Stations
If you have problems with the base, unplug it to reset it. Plug it back in after at least a minute. If you have problems with a cordless handset or want to replace one, reset it:
1.Press & hold END and # at the same time until you see the System Reset menu.
2.If you still have the base the handset is registered to, select Deregister HS, then select the handset you want to reset. If you don’t have that base anymore, select Base Unavailable.
3.To confirm, select Yes. The handset displays Handset not registered.
Registering Handsets
If Handset not registered displays on a handset, register the handset to a base before using it.
1. On the base, open the menu and select Register Accy.
2. On the handset, press and hold # until the handset displays Registering.
3. Wait until the display says Registration Completed (about 30 seconds), then pick up the handset; press home/flash.
##If you don’t hear a dial tone or the display says Registration Failed, charge the battery completely, then try again.
English - 25
