RELEASE MATERIAL INSTALLATION
The following procedures are the procedures for installing the Teflon sheets on to the upper platen on the Garland Xpress grill. The components shown below are included with your grill when purchased.
Slide release material rod through hemmed end of the release material sheet.
Holding the bottom of the release material sheet in place, gently pull the sheet toward the front of the platen.
Thread the front edge of the release material sheet behind the release material bar on the front of the platen, then around the top and down over the front of the bar as shown.
Place locking clips over release material sheet and press into place over release material bar.
RELEASE
MATERIAL
BAR RELEASE
MATERIAL
LOCKING
CLIP (1)
Hook release material rod on brackets located at the rear of the upper plate
RELEASE
MATERIAL
UPPER PLATEN (side view)
FRONT OF GRILL 
| UPPER PLATEN (side view) |
| RELEASE MATERIAL HOOK |
RELEASE | RELEASE MATERIAL SHEET |
MATERIAL ROD |
|
| REAR OF GRILL |
Check alignment and tightness of release material against upper platen.
NOTE: Make sure release material fits smoothly over upper platen. Installing release material sheets too tight may cause premature failure of the sheet.
Release sheets are reversible and should be flipped over and reattached on a daily basis. For instructions on cleaning release sheets, see Step 17, Under Daily Cleaning in Cleaning and Maintenance section.
A release material sheet must be replaced when:
•Product sticks to release material.
•Carbon
•Tearing occurs in the sheet’s cooking area.
•Release material coating is worn off sheet.
Part # JIBSM08 Rev.6 (08/04/09) | Page 19 |
