![](/images/new-backgrounds/1276377/27637755x1.webp)
PROGRAMMING continued
To View the Flash Number:
1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press
one, (1) time to display “PROGRAMMING MODE SYSTEM INFO.”
5.Press four, (4), times to view the Flash Number. “FLASH NUMBER X…X” is displayed. (Flash number varies by grill).
6.Press to return to “PROGRAMMING MODE SYSTEM INFO”.
7.Pressto exit.
To View the Software Number:
1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press one, (1) time to display “PROGRAMMING MODE SYSTEM INFO.”
5.Press five, (5), times to view the Software Number. “SOFTWARE NUMBER X…X” is displayed. (number varies by grill).
6.Press to return to “PROGRAMMING MODE SYSTEM INFO”.
7.Pressto exit.
To View the Download Number:
1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press one, (1) time to display “PROGRAMMING MODE SYSTEM INFO.”
5.Press six, (6), times to view the Download Number. “DOWNLOAD NUMBER X…X” is displayed. (Download number varies by grill).
6.Press to return to “PROGRAMMING MODE SYSTEM INFO”.
7.Pressto exit.
System Setup
To Change temperature Units, (°F or °C):
1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.
5.Press to enter system setup. “TEMP DISPLAY FAHRENHEIT (or CELSIUS)” is displayed.
6.Press to change the temperature units to either Fahrenheit or Celsius.
7.Pressto save the changes.
8.Press to return to “PROGRAMMING MODE SYSTEM SETUP”
9.Pressagain to exit.
To Change Gap Setting Display Units:
1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.
5.Press two, (2), times. “GAP SETTING DISPLAY INCHES (or MILLIMETERS)” is displayed.
6.Press to change the Gap Setting Display units to either Inches or Millimeters.
7.Pressto save the changes.
Page 28 | Part # JIBSM08 Rev 7 (08/04/09) |