PLATEN ZEROING
Turn Master power switch “ON”, wait for controllers to display “OFF”.
Note: Release sheets should not be installed during this procedure.
1.Press and hold 
for three, (3) seconds. “ENTER CODE” is displayed.
2.Using the Product buttons,
3.Press 
to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.
4.Press 
two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5.Press 
six, (6) times. “PLATEN SET +/- XX” is displayed. (XX=numbers that will vary from grill to grill.)
6.Allow time for grill to heat and turn ready. Press both the Cancel (Green) and Standby (Black) buttons simultaneously to lower the upper platen. Press the Cancel (Green) button to raise the platen. Now, press both the Cancel (Green) and (Black) Buttons to
7.Remove platen adjuster caps from all four adjustment points on each platen. Remove the four locking caps from the adjustment points.
8.Using the adjusting tool lower platen until adjusting tool touches the arm assembly.
9.With gapping tool, adjust right rear of platen until the gapping tool fits snugly between the upper platen and grill surface.
10.Move next to the left front adjuster and raise the platen until the gapping tool fits snugly between the upper platen and grill surface.
11.Next go to the left rear adjuster and raise the platen until the gapping tool fits snugly between the upper platen and grill surface.
12.Move next to the right front adjustment and raise the platen until the gapping tool fits snugly between the upper platen and grill surface.
13.Repeat steps
(See diagram below.)
14.Replace the platen adjuster locking caps “hollow side down” and tighten snugly. Replace platen adjuster caps.
15.Repeat steps
Insert gap tool directly below platen adjusters.
Page 16 | Part # JIBSM08 Rev 7 (08/04/09) |
