Garland XG36-JIB To Change Platen Set, To Change Instant-On Time, To Change Control Type

PROGRAMMING continued

•Temperature is currently falling from a detected peak of 360°F or higher..

•Temperature is falling and has fallen 2°F from a detected peak that is within the 350-360°F range.. (i..e.. calibration would be allowed at 355°F if the achieved peak temperature was 357°F)

•Temperature is rising through the 350-360°F range as a result of a heat on pulse of less than 30 seconds..

To Change Platen Set:

1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.

2.Using the Product buttons, 0-9 enter the code, (1251). “ENTER CODE **** ” is displayed.

3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.

4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.

5.Press seven, (7) times. “PLATEN SET +/- XX” is displayed. (numbers will vary by grill)

6.Use and to change the Platen Set to the correct value.

7.Pressto save the changes.

8.Press to return to “PROGRAMMING MODE MENU ITEMS”

9.Pressagain to exit.

To Change Instant-On Time:

1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.

2.Using the Product buttons, 0-9 enter the code, (1251). “ENTER CODE **** ” is displayed.

3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.

4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.

5.Press eight, (8) times. “INSTANT ON TIME XX:XX” is displayed. (numbers will vary by grill).

6.Use and to change the Instant on Time to the desired value.

7.Pressto save the changes.

8.Press to return to “PROGRAMMING MODE MENU ITEMS”

9. Pressagain to exit.

To Change Control Type:

Note: this must be verified if the control is changed, match the new control to the grill.

1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.

2.Using the Product buttons, 0-9 enter the code, (1251). “ENTER CODE **** ” is displayed.

3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.

4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.

5.Press nine, (9) times. “CONTROL TYPE ELECTRIC (or GAS)” is displayed. (type varies by grill).

6.Use and to change Control Type to match the design of the grill.

7.Pressto save the changes.

8.Press to return to “PROGRAMMING MODE MENU ITEMS”

9.Pressagain to exit.

To Turn Extended Time On/Off:

1.Press and hold for three, (3) seconds. “ENTER CODE” is displayed.

2.Using the Product buttons, 0-9 enter the code, (1251). “ENTER CODE **** ” is displayed.

3.Press to enter the Programming Mode. “PROGRAMMING MODE MENU ITEMS” is displayed.

4.Press two, (2) times. “PROGRAMMING MODE SYSTEM SETUP” is displayed.

5.Press ten, (10) times. “EXTENDED TIME NO (or YES)” is displayed.

6.Useandto turn Extended Time on or off.

7.Pressto save the changes.

8.Press to return to “PROGRAMMING MODE MENU ITEMS”

9.Pressagain to exit.

Page 30 Part # JIBSM08 Rev 7 (08/04/09)