Epson N2700 LC1 to LC3 Type, Multibin Settings and Corresponding Outbins Available, Paper Source

EPL-N2700	Revision A
	Table 1-30.
LC1 to LC3 Type
	“Multibin” Settings and Corresponding Outbins Available

These are basically same as the MP Type but because special paper cannot be fed from the LC1 - LC3, “Letterhead”, “Bond”, “Transprnc”, and “Labels” can not be selected.

Paper Source

The priority for selecting the paper source is in the order of MP Tray > LC1 > LC2 > LC3. (Applicable when “MP Tray Mode” is set to “Normal”.) The combination of the optional paper sources and the name during the selection is as shown in the below:

Table 1-29. Combination of the Optional Paper Cassette and

Corresponding Names

MP Tray	LC1	LC2	LC3	Remarks
Standard	Standard	---	---	No option installed
Standard	Standard	500-sheet	---	One 500-sheet cassette
		cassette unit		unit installed
Standard	Standard	500-sheet	500-sheet	Two 500-sheet cassette
		cassette unit	cassette unit	units installed
Standard	Standard	LCC *	---	LCC installed
Standard	Standard	500-sheet	LCC *	One 500-sheet cassette
		cassette unit		unit and LCC installed

*: Large Capacity Lower Cassette

Multibin

The values that can be selected for the “Out Bin” in the “Printing Menu” vary depending on the selection made for the “Multibin” in “Setup Menu” as shown in the following table:

	Mailbox	Sorter	Multisort	Stacker
Without option	Face-down	Face-down	Face-down	Face-down
	Face-down,	Face-down,	Face-down,	Face-down,
5-bin unit	Mailbox 1,
		Sorter	Sorter	Stacker
	Mailbox 2 - 5
	Face-down,	Face-down,	Face-down,	Face-down,
10-bin unit	Mailbox 1,
		Sorter	Sorter	Stacker
	Mailbox 2 - 10

NOTES:

1.When an optional unit is installed, the standard Face-down can no be used. So, “Face-down” in this case means another device.

2.If any item which can not be selected due to operation mode of the Outbin is selected by the EJL or ESC/Page command, the selection is ignored,

3.If Face-down is selected in the 5-bin or 10-bin mailbox mode, paper is output to Mailbox 1.

Output Tray Selection Specifications

￿<5-bin unit>

When “Multibin = Stacker” and “Outbin = Stacker” are selected:

The sequence of outbin destinations is Bin2 > Bin3 > ---> Bin 5 >

￿Bin1.

The printer searches some consecutive empty bins in the order of Bin 5 - Bin 2, and paper will be output to the empty bin which found last in the search.

￿<10-bin unit>

￿When “Multibin = Stacker” and “Outbin = Stacker” are selected:

The sequence of outbin destinations is Bin10 > Bin9 > ---> Bin 2 > Bin1

Product Description Panel Operation 39