EPSON | Rev. A |
4.2.21 Fusing Section
4.2.21.1 Fuser Unit Removal
1.Open the vertical transport door. (See Section 4.2.4.)
2.Remove the Front Cover. (See Section 4.2.17.)
3.Disconnect the heater lamp harness from the connector (heater power source) on the front and release the harness from the cable clamp and edge cover which are on the printer frame.
Figure 4-36. Connector (Front) Removal
4.Open the Fuser Unit and disconnect the connectors at the rear side.
5.Remove two screw (3504 and 4011) securing the Fuser Unit to the printer main body.
Figure 4-37. Fuser Unit Removal
The Fuser Unit is hot right after printing. Therefore, be
C A U T I O N
careful not to get burnt when handling the Fuser Unit.
If you have replaced the Fusing Unit, perform “Fuser Counter Clear” in the maintenance mode. (See Chapter 1 / Section 1.4.5.)
Chapter 4 Disassembly/Assembly | 113 |
