Epson N2700 manual Message Descriptions

EPL-N2700 Revision A

3.1.1.2 Message Descriptions

￿This section describes the messages specific to EPL-N2700.

x Error yyy (error)

Given when a problem occurs with the paper feeders or output bins. <Remedy>

Power down temporarily, check the connection on the device where the error has occurred and start-up again.

￿If the problems is not solved, there is a possibility of malfunction. Check Duplex P-size (error)

Occurs when duplex printing cannot be done because the paper size that has passed and the paper size selected for duplex printing were deferent.

<Remedy>

Open the cover on the paper feed path and remove the jammed paper, then close the cover.

￿If the problems is not solved, there is a possibility of malfunction. Jam xxxx (error)

A paper jam has occurred at the indicated location. If more than one locations are indicated, it means there is a possibility of jammed paper near the indicated locations. Therefore, the numbers of locations and the jammed paper do not match.

<Remedy>

Open the cover indicated, remove the jammed paper, and close the

￿cover.

Face-down Full (error)

The printer attempts to eject paper to the FD, but the FD was full. Only occurs when the multibin or finisher is installed. (Does not occur without any options installed.)

<Remedy>

After removing paper from the FD, press the Continue button, and

￿the printer resumes printing. Multibin <N> Full (error)

The printer attempts to eject paper to the multibin <N>, but the bin is full.

<Remedy>

After removing paper from the multibin, press the Continue button,

￿and the printer resumes printing. Cover A - G Open (error)

Cover at the indicated position is open. <Remedy>

￿Close the cover indicated. Multibin is removed

10-bin multibin is not properly installed. The 10-bin multibin was separated from the printer to open the door to remove the jammed paper, and the 10-bin multibin is left separated from the printer. <Remedy>

￿Install the 10-bin multibin to the printer main body. Manual Feed ssss ttt (error)

When the manual feed mode is selected by the panel or command, the selected paper source and paper size are indicated before printing starts.

<Remedy>

Press the Continue button, and printing starts. If paper is loaded in the selected paper source ssss, the printer feeds paper from that paper source. If not, the printer feeds paper from the paper source of the highest priority among the ones which hold paper. In case

Troubleshooting Overview 82