Epson N2700 manual SelecType Option 7/7, Maintenance Menu *24

EPL-N2700 Revision A

	Table 1-28.	SelecType Option (7/7)
	MENU Button
	ITEM Button	VALUE Button
	Maintenance Menu *24
	Engine Status Sheet
	Fuser Counter Clear
	MP Counter Clear
	LC1 Counter Clear
	LC2 Counter Clear *21
	LC3 Counter Clear *21
	TR Counter Clear
	Errlr Long Clear
NOTES:

1:Appears only when an optional PostScript Level 3 DIMM is installed.

2:Appears only when an optional TypeB Interface Card is installed.

3:Appears and can be selected only when an optional lower cassette unit is installed.

4:Does not appear on the panel nor status sheet.

5:When "Auto" is selected, the following paper sizes can be detected.

-North American version: LT, HLT, LGL, EXE, GLG, GLT, B

-Other versions:A3, A4, A5, IB5, LTR, LGL, F4

6:Appears and can be selected only when 5-Bin Unit or 10-Bin Unit is installed and the Stacker mode is enabled.

7:Appears and can be selected only when 5-Bin Unit (Mail box 1 - 4) or 10-Bin Unit (Mail box 1-9) is installed in the Mailbox mode.

8:Does not appear.

9:Effective only in the ESC/Page or PCL mode.

10:Appears only when an optional Duplex Unit is installed.

11:Appears only when an optional 5-Bin Unit or Finisher is installed.

12:Does not appear.

13:Appears but not to be selected.

14:STANDBY command of the EJL is also supported. The default is 60 minutes. (Not intended for users.)

15:Does not appear on the panel nor status sheet. Only set in EJL.

16:Appears only in the GLike mode.

17:The selected value is not effective until the next warm boot or power on.

18:Appears only when the NLSP Bitmap 3 Plus ROM DIMM is installed.

19:Default for the North American version.

20:Default for the versions other than the North American version.

21:Appears even though the optional unit is not installed. The counter is also cleared.

22:Either “Height” or “Pitch2 appears, depending on the selected font type;

-Constant pitch font: “Pitch”

-Proportional pitch font: “Height”

23:Appears only when an optional Font DIMM is installed in the optional ROM DIMM Socket.

24:Appears when the maintenance menu is activated by the power-on service function.

25:Appears and can be selected only when an optional 5-Bin Unit or 10-Bin Unit is installed in the Sorter or MultiSort mode.

26:Does not appear on the panel nor status sheet but can be set in the EJL or PJL.

27:Appears and can be selected only when an optional 5-Bin Unit or 10-Bin Unit is installed. After exiting the panel setting mode in which the selection has changed, warm-boot is executed. Also, after the selection has changed, "Test Menu" is not shown until the panel setting mode is terminated.

Product Description Panel Operation 37