| Revision A |
none of the paper source has paper in it, the message “Manual Feed ssss ttt” is indicated again. Even though the fed paper size
does not match ttt, “Check Paper Size” is not indicated. Remove Output Paper (error)
When the multibin mode is changed from the previous one, paper remains in the multibin unit.
<Remedy>
Remove all paper in the multibin unit, and the error is automatically
cleared.
Can’t Print Duplex (error)
Duplex print is not available due to restricted matter on the duplex print.
<Remedy>
Press the Continue button, and the printer starts single printing. If “Auto Cont” in the Config menu is activated, the printer starts single printing after specified period of time. In case the error relates to the paper source device, the printer may starts duplex printing when the
device’s condition changes and the error is cleared. Invalid option (error)
The option currently installed is not supported by the printer. <Remedy>
Turn the printer off and remove the corresponding option. Check Paper Type (warning)
When “Paper Source” is set to “Auto” and paper type is specified, none of the paper sources holds paper whose size and type both meet the selected paper size and type. So the printer loads paper from the paper source which holds the paper that does not match the selected paper type but the size only. In case the paper source set for the paper of the selected paper size and type is empty, “Paper Out” error occurs instead of this warning.
Outbin Select Error
The output device used is other than selected one because the selected device is restricted.
3.1.2 Service-call Error
The
3.1.2.1 Engine Related Error
The following table lists the engine related errors which can occur in this printer.
Table 3-2. Engine Related Error List
Error Code | Description | |
E0004 | Main motor error | |
|
| |
E0005 | Fan motor error | |
E0006 | Polygon motor error | |
|
| |
E0008 | Engine EEPROM error | |
E0014 | Error in communications with engine | |
|
| |
E0015 | Error in communication with option | |
E0030 | Fuser error | |
|
| |
E0032 | Fuser error (overheat) | |
E0034 | Fuser error (low temperature error) | |
|
| |
E0041 | IU motor error | |
E0046 | HSYNC detection error | |
|
| |
E0047 | IU fuse blown error | |
|
|
Troubleshooting | Overview | 83 |
