Epson N2700 manual This printer has a non-volatile memory Eeprom to

EPL-N2700 Revision A

￿Form Feed button

If the printer contains data but is not enabled for printing (if Form Feed lamp is on), this switch causes printer to output printing results and eject the paper. (This button does not cause ejection if Form Feed lamp is off.)

Continue button

Clears error (if pressed while Continue LED is blinking). When printer is in On-Line state, this button will also clear any warning

￿display that may appear on the LCD.

SelecType / ALT button

Selects the panel setting mode: OneTouch Mode 1, OneTouch Mode 2, or SelecType Mode. Also operates as a ALT key. Panel button operations vary according to the currently selected panel

￿setting mode.

MENU button

Selects the corresponding OneTouch mode setting listed above this button, or selects the SelecType menu if in SelecType mode. Press

￿this button when the printer is on-line to enter SelecType mode.

ITEM button

Selects the corresponding OneTouch mode option listed above this button, or selects the function available within the current menu,

￿after entering the SelecType mode.

VALUE button

Selects the corresponding OneTouch mode option listed above this button, or selects the parameter available within the current item,

￿after entering the Item of the SelecType mode.

ENTER button / Status Sheet print

Selects the corresponding OneTouch mode option listed above this button, or accepts the setting currently shown on the LCD as a new

setting when in SelecType mode.

Press this button twice when the printer is on-line to print the Status

￿Sheet.

RESET (ALT + Continue)

Pressing the Continue button while holding down the ALT button will reset the printer. The LCD will display the message RESET. To generate a complete reset (warm boot), continue to hold down these buttons for approximately five seconds after the RESET message appears; the message will then change to RESET ALL and the printer will start warm-up processing.

1. This printer has a non-volatile memory (EEPROM) to

C A U T I O N

store various setting values and print data. If the printer power is turned off while it is writing data, the ongoing writing operation is not completed and an error may occur at the next power on. Therefore, be sure not to turn the printer off when the printer is in any of the following conditions because a writing operation is processing.

Printer is turned on but the On Line LED has not come on yet.

￿On Line LED is blinking.

Printer is printing. (PF motor is live.)

2.To stop printing, press the On Line button or perform Job Cancel / Reset operation.

Product Description Panel Operation 33