Uniden D22802 manual Getting Started, Installing Your Phone

CAUTION! Risk of explosion	a regular indoor (120V AC)
if battery is replaced by an	power outlet. Connect any
incorrect type! Dispose of used	chargers the same way.
batteries according to the	6. Place a handset in the base with
instructions. Do not open or
	the display facing forward. If
mutilate the battery. Disconnect
	the display doesn’t light up,
the battery before shipping this
product.	reseat the handset or connect
For more details, see the	the base to a different outlet.
	For 2 or more handsets, place
Important Information section.
	each handset in a charger.
Getting Started	Charge all handsets
	completely (about 15 hours)
Installing Your Phone	before using.
Charge the Battery	Connect the Telephone Cord
1. Unpack all handsets,	Use the telephone cord to connect
battery	the TEL LINE jack on the base to a
packs, and	standard telephone wall jack.
battery	Test the Connection
covers. If
	1. Pick up the handset and press
you need
	Talk. The handset sounds a dial
to remove
	tone, and the display shows
a cover, press in on the notch
	Talk.
and slide the cover down and
	– If you don't hear a dial tone or
off.
	the display says Check Tel Line,
2. Line up the battery connector
	check the connection between
with the jack inside the	the base and the phone jack.
handset; the connector only fits	2. Make a quick test call. (Press
one way.	End to hang up.)
3. Push the connector in until	– If you keep hearing a dial tone,
it clicks into place; tug gently	change to pulse dialing.
on the wires to make sure the	– If there’s a lot of noise, check
battery is securely connected.	for interference (see p. 22).
4. Replace the battery cover and	3. Test all handsets the same way.
slide it into place.	If you can't get a dial tone,
5. Use an AC adapter to connect	move the handset closer to the
	base.
the power jack on the base to

English -