2.Check to make sure the battery is fully charged. (If you don't see the "battery full" icon, check to make sure the battery is properly connected).

3.Change the dial mode (instructions below).

Changing the Dial Mode (Australian Model Only)

Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If your phone company uses pulse dialing, you will need to change your phone’s dial mode. If you don't get a dial tone or can't connect to the telephone network, please follow the steps below to modify your phone’s settings:

1.

Press [menu/clear]. Select the GLOBAL SETUP menu, and then the

 

DIAL MODE submenu.

2. Scroll [ ] to select PULSE.

3.

Press [select/ ] . You will hear a confirmation tone.

 

If you ever need to change the dial mode back to tone dialing, follow the

 

same procedure, but select TONE in step 2.

Installing the Belt Clip

Line up the holes on each side of the handset. To attach the belt clip, insert into the holes on each side of the handset. Press down until it clicks.

To remove the belt clip, pull either side of the belt clip to release the tabs from the holes.

[16]

Page 17
Image 17
Uniden DSS3455+2, DSS3455+1, DSS3435+1 owner manual Changing the Dial Mode Australian Model Only, Installing the Belt Clip