Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. (See "About the digital security code", page 7.) In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1)Remove the handset from the base unit. Press and hold find hs on the base.
2)While the handset is emitting the paging sound, place the handset on the base unit holding find hs. The paging sound stops. Leave the handset on the base for more than 3 seconds. A new random security code is set.
Installing the Beltclip
To attach the beltclip | To remove the beltclip |
Insert the beltclip into the holes on | Pull both sides of the beltclip to |
each side of the handset. Press down | release the tabs from the holes. |
until it clicks. |
|
Headset Installation |
|
Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert headset plug into the headset jack. Your phone is ready for
(Headset may be purchased by calling the Uniden Parts Department or visiting the web site. See Page 8.)
If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged.
INFORMATION | ADDITIONAL |
A D D I T I O N A L I N F O R M AT I O N [ 53 ]
