Scan mode operation
You can save channels into memory and then use scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning.
When it detects a signal, the radio stays on the channel until you press the
Channel Up button or the signal stops.Resume scan
08 
10 
11 
12 
13 
14 
15 
17
The radio scans about
5 channels in 0.5 seconds.
Using the radio in scan mode
•To activate scan mode, press
•You must have at least two channels in memory to start a scan.
•You cannot transmit while in scan mode.
•To save a channel into memory, select the channel, then press the Mem button. The Mem icon shows on the display whenever you tune to that channel.
•To remove a channel from memory, set the radio to that channel, then press the Mem button. The Mem icon no longer shows on the display.
•When the radio stays on a channel, press Channel Up to leave that channel and resume scanning.
•To end the scan, press the
Uniden MHS75 Radio Owner’s Manual |
