S E T T I N G U P Y O U R P H O N E
Raising the Antenna
Before using your phone, be sure to raise its antenna to the vertical position.
Connect the base unit
SETTING UP YOUR PHONE
If you want to install the base unit on the wall, see page 7.
1.Connect the telephone line cord to the TEL LINE jack and to a telephone outlet.
2.Connect the AC adapter to the DC IN 9V jack and to a standard 120 V AC wall outlet.
3.Set the base unit on a desk or tabletop and place the handset on the base unit. Then raise the antenna to a vertical position.
Route the cord |
|
To AC outlet |
|
To DC IN 9V |
|
AC adapter(supplied) |
|
To telephone outlet | To TEL LINE |
| |
Telephone line cord |
|
(supplied) |
|
Place the power cord so it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.
Adjusting Ringer/Volume Controls
▼Ringer Tone and Volume
1.While the phone is not in use, press volume 
.
2.The phone has two ringer tones, each with two volume levels.
Press volume 
again until you hear the ringer tone and volume level you want.
▼Setting the Handset Earpiece Volume
1.While you are on a call, press volume 
.
2.The phone has four receiver volume levels, Low, Medium, High, and Maximum. Press volume
again until you hear the volume level you want.
When you hang up, the phone keeps the last volume setting selected.
[ 9 ]
