1.Hold the base of the camera stand where you want to mount it and mark the location of the screw holes.
2.Drill holes using the 5mm drill bit.
3.Insert anchors.
4.Use the included screws to attach the base to the wall or ceiling. You can also screw the base into a flat surface such as a tabletop if needed.
5.Before attaching the camera, tug gently on the stand to make sure it is securely in place.
Attach the camera |
|
|
|
|
|
|
|
|
1. For each camera, attach |
| Tighten the brace against | 1 | Attach the camera | ||||
the camera bracket to the | 2 | to the mounting | ||||||
the camera to |
| screw and turn it | ||||||
mounting screw. You can |
| secure it |
| to the desired | ||||
attach the stand to the top or |
| in place. |
| direction. | ||||
the bottom of the camera as |
|
|
|
|
|
|
|
|
needed. Tighten it a few turns, | 3 |
|
|
|
|
|
|
|
then turn the camera to face |
|
|
|
|
|
|
| |
Loosen the |
|
| ||||||
the direction you want. |
|
| ||||||
| wingnut to |
| Adjust the post to | |||||
2. Tighten the camera brace up | unlock the |
|
|
|
| 4 | ||
|
| |||||||
against the camera to secure it | mounting | the correct angle, | ||||||
post. |
|
|
|
|
|
| then tighten the | |
into place. |
|
|
|
|
|
|
| wingnut to lock the |
|
|
|
|
|
|
| ||
3. Unlock the mounting post by |
|
|
|
|
|
|
| post into place. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
turning the wingnut to the left |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
a few turns. |
|
|
|
|
|
|
|
|
4. Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.
5.Attach the antenna to the rear of the camera. Power Up the Monitor
1.Press and hold the Power button on the left side of the monitor for 1 - 2 seconds to turn it on.
9
