Uniden UDW10055 user manual Using the Menu, CAM4

Using the Menu

To open the menu,				The selected
press	OK			item is				Use LEFT
				highlighted				and RIGHT
		Audio Vol						to scroll
			10				9		11
								through the
		Scan Time	OFF
								options for
		CAM1	ON
Use UP								the item
		CAM2	ON
and DOWN
		CAM3	ON
to move								Brightness 10
		CAM4	ON
the cursor								TV out NTSC
		Pair CAM	1 2 3 4					Power Save OFF
		System	Setup			To open		the
		Factory	Reset			System		Setup
						sub-menu, press OK
					To close the menu, press OK
Item	Use it to
Audio Vol	Adjust the volume of the audio from the camera. Choose a value from 0 (off)
	through 20 (maximum).
Scan Time	Set the length of time the receiver spends on each active camera during a scan
	(see page 16) or activate quad display (see page 17).
CAM1 – CAM4	Turn each of the four camera channels On (enabled) or Off (disabled).
Pair CAM	Pair a camera to the selected channel (see page 14).
System Setup sub-menu
Brightness	Adjust the brightness of the display. Choose a value from 1 (min) through 15
	(max).
TV out	Change the video output format from NTSC (North America) to PAL (Europe).
Power Save	Turn on power save mode. If you set this field to Auto, the display turns off if it’s
	idle for more than one minute. (The audio will remain active.) To turn the display
	back on, press OK.
Factory Reset	Reset the receiver to factory defaults. Any changes or settings will be lost.

11