Resetting Your System

If the static is only on 1 camera	If the static is on all cameras
--Check near the camera for one of the common	--Check near the receiver for the source of
interference sources.	interference.
--Try moving the camera away from a suspected	--Try moving the receiver away from a
source, or try moving the suspected source so it’s	suspected source, or turn off the source if
not between the camera and the receiver.	possible.
--Try moving closer to the receiver. There is always	--Try raising the receiver’s antenna so it
more noise at the edges of the receiver’s range.	stands straight up.

Resetting the camera or receiver will erase any changes and set all values back to the default.

You should only reset your system under the following conditions:

Resetting the camera	Resetting the receiver

--You are unable to pair the camera to the	--The buttons on the receiver are not responding.
receiver.	--The image on the screen is frozen, and resetting
--The image on the screen is frozen.	the camera did not help.

To reset the camera, unplug the AC adapter. Wait at least 15 seconds, then reconnect the AC adapter.

To reset the receiver:

1.Unplug the AC adapter and make sure the power is off.

2.Extend the antenna and locate the hole for the reset button.

3.Insert a small object (like a pencil point or an unbent paper clip) into the hole and gently press in.

4.Reconnect the AC adapter and let the battery charge fully.

Uniden UDW10055 user manual Resetting Your System, Resetting the camera Resetting the receiver