Uniden UH-099 owner manual Receiver SELCALL ID, UUUUf-t, f-tf-tf-tf-tU, LFlaShing

Receiver SELCALL ID

To program your own receiver SELCALL ID, perform the following procedure.

Press and Hold ITSQ I,then turn on the Power.

1.1 Initial Display and Status (factory default: 00000)

RX SELCALL Code Programming

	TSQ	I
,-, It ,-, ,-, ,-,	,~	~
		"
UUUUf-t

1.2When the IMEM Ikey is pressed while in this condition, the last digit will begin

ENT

to flash and RX Tone Editing is possible.

TSQ	,~~	I
f-tf-tf-tf-tU		"~
,-, ,-, ,-, ,-, ,-,

LFlaShing

Use the <J or [> to select the digit position. The selected digit will flash.

Rotate the 0 to change the active digit value.

Channel Knob

When finished, press IMEM Ito store the RX Code into memory.

ENT

The programmed code flashes and three successive beeps are heard.

Press ITSQ Ifor about 1.5 seconds to exit. The radio returns to normal operation.

Or press ITSQ Imomentarily to go to the next programmable parameter.

1.3 Selecting 5 or 6 Tone Format

1.31 From 5 to 6 Tone Format Setting

While the 5th digit is flashing, press [>. A space bar [ -] will appear and

flash.

Page 20