Uniden UH-099 owner manual Too I ,~, Usethe 0 to change the Lead-in Tone value

When finished, pressl MEMIto store onto memory. The displayed Lead-in Delay

ENT

stops flashing and three successive beeps will be heard. pressl TSQI for about 1.5

seconds to exit. The radio returns to normal operation. Or press ITSQ Imomentarily

to go to the next programmable parameter.

Lead-in Tone

The Lead-in Tone, when programmed, "rides" on the Lead-in Delay. Hence, when transmitting a SELCALL ID, a continuous tone will be heard for the duration of the Lead-in Delay.

The main purpose of the Lead-in Tone is to increase the probability of contact between your unit and another radio when TSQ Scanning.

Normally during TSQ Scanning, if a carrier is detected and the unit does not notice SELCALL information on its first "glance" of the particular signal, scanning resumes.

But if a Lead-in Tone is present, the unit continues to wait until the SELCALL ID is received.

4.1From the Lead-in Delay Status (3.1), press ITSQ Iand the following mode appears.

TOO I ,~

,- ,- ,,LI , O'rC

Note: Tone _1 is the factory default setting of the UH-O99 for Lead-in Tone.

4.2Next press IMEM Iand Lead-in Tone Editing is possible.

ENT

TOO I ,~

,- ,- I, LI ,onc

L- Flashing

Usethe 0 to change the Lead-in Tone value.

Channel Knob

Page 25