Uniden UH-099 owner manual Call Alarm Continue Mode, 00000

Call Alarm Continue Mode

1.The unit will transmit an Acknowledge Tone to the Caller.

2.Initially emits an alarm of four successive beeps for 20 seconds and then two successive beeps every four seconds continuously unless answered.

3.Never resumes the Quiet Condition.

4.Continues to check if incoming codes have your Receiver SelcalllD even though

the Quiet Condition is already opened. When detected, it will send an Acknowledge Tone to the caller and then resets the Call Alarm.

.: For both of the above mentioned modes, transmission by using the Press-to- Talk button is possible when the "TSQ" icon is flashing.

Default Setting (Factory Default)

A. RX SELCALL ID:	00000
B. TX SELCALL ID:	00000
C. Tone Period:	40msec
D. Lead-in Delay:	500msec
E. Lead-in Tone:	Tone "1"
F. Alarm:	Auto
IMPORTANT

Be sure that the Tone Format (5 Tone or 6 Tone), Tone Period Setting and the Lead-in Tone for all of the radios in your group are all the same. Otherwise you will not be able to selectively callone anothereffectively.

Page 28