ASSEMBLY INSTRUCTIONS
Your furnace is shipped from the factory in four (2) packages. 1) the furnace, 2) the blower. The draft kit and parts box containing all parts necessary, and the fan thermodisc kit is boxed and packed in the firebox or ash pan. Before assembling the furnace, check to make sure there is no shipping damage, and that all necessary parts are located in the firebox. See parts list below.
If you find shipping damage or any of the parts missing, contact the dealer immediately. He will take the necessary steps to correct the problem.
Parts List
All models include the following: |
| ||
(2) | Door Handles | (1) 1/4" x 1" Hex Bolt | |
(1) | Fuel Door Latch | ||
(1) | Ash Door Latch | (1) | 3/8" Lock Nut |
(2) | 1/2" Washers | (1) 3/8" Jam Nut | |
(9) | 1/4" Kep Nuts | (2) | 3/8" x 2 1/2" Carriage Bolt |
(2) | Spin Draft | (6) | 1/4" x 3/4" Hex Bolts |
(4) | Brass Coil Knobs | (1) | Smoke Door |
(1) | Shaker Handle | (1) Hinge Bracket | |
|
| (2) | 1/4" x |
|
| (2) | Smoke Door Clips |
DOOR HANDLE INSTALLATION
Insert door handle into door. From rear side of door place 1/2" washer over threaded part of door handle. Then attach 1/2" lock nut, being careful not to over tighten. Handle should turn freely.
FUEL & ASH DOOR LATCH INSTALLATION
With two 1/4" x 3/4" hex bolts, attach the door latch to the door latch mounting bracket on the left side of door frame as illustrated. Adjust latch until door closes securely.
FUEL DOOR
ILLUSTRATION
ASH DOOR
ILLUSTRATION
LOCK
WASHER
HEX |
|
NUTS | 6 |
|
BRICK INSTALLATION
NOTE: Prior to operation, be sure to remove brick retaining strips.
MODEL 1600M - (6) BRICKS ON EACH SIDE
FIREBOX LEFT SIDE
BRICK RETAINING STRIP
SLIDE 4th BRICK BACK
BEFORE INSTALLING 5th
AND 6th BRICK
FIREBOX:
The firebrick must be inserted on each side resting on the grate frame. First, place cut brick in each back corner. Place remaining brick in place.