Atlas OCAP M1056L.fm Page 12 Friday, December 22, 2006 6:10 PM |
(for example, TV/VCR). If you perform this procedure correctly, the VCR key will blink twice.
NOTE: If the VCR key did not blink twice after enter- ing the codes last digit, repeat steps 2 through 3 and try entering the same code again.
If you’ve located a setup code that works for your combo device (for example, a TV/VCR Combo) and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see “Programming Device Control” starting on page 10).
4.Aim the remote control at your combo device
(for example, TV/VCR Combo) and press PWR once. The device should turn off. If it does not respond, repeat steps 2 through 3, trying each code listed for your brand until you find one that works. If it still does not respond, try searching for the code (“Searching for Your Code” starting on page 13).
5.For future reference, write down each working device code in the boxes below:
TV/VCR or TV/DVD Code
TV Code (if used)
SEARCHING FOR YOUR CODE
If your home entertainment device does not respond to the Atlas OCAP
For example, to search for a code for your TV:
1.Turn on your TV.
2.On the remote control, press TV once; it will blink once. Then press and hold SETUP until
the TV key blinks twice.
www.urcsupport.com/atlasocap
12
