www.urcsupport.com/atlasocap
20
PROGRAMMING CABLE ID LOCK The Atlas O CAP 5- Device Remote C ontrol w ith Lea rning
is locked at the factory to operate your cable provider’s
set top box. Howeve r, if you have anot her brand or
model of cable converter or satellite service that you
would like to control, then you’ll need to perform the
following steps to unlock the ID Lock, enter a new
manufacturer’s code, and lock the ID Lock again.
1. Turn on the cable converter.
4. Perform the instructions under
“Programming Device Control” on page10 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the cable ID Lock.
PROGRAMMING MACRO KEYS The Atlas O CAP 5- Device Remote C ontrol w ith Lea rning
includes two macro keys (located directly below the
MUTE and LAST keys). Macro keys allow you to s et up key
macros to activate certain keys in a specific order. For
example, you can set up a key macro to change the
channels on your TV, raise or lower the volume, and
start recording on your VCR, all with the touch of one
key. If you want to change the macros stored in a
previously-programmed macro key, you’ll need to clear
the key first (see “Clearing a Macro Key” on page21).
2. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks t wice.
3. Enter 9 8 2. The CBL key will blin k four
times, indicating ID Lock is unlocked.
5. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks t wice.
6. Enter 9 8 2. The CBL key will blin k twice,
indicating ID Lock is again locked.
Atlas OCAP M1056L.fm Page 20 Friday, December 22, 2006 6:10 PM