www.urcsupport.com/atlasocap
12
(for example, TV/VCR). If you perform this
procedure correctly, the VCR key will blink
twice.
NOTE: If the VCR key did not blink twice after enter-
ing the codes last digit, repeat steps 2 through
3 and try entering the same code again.
If you’ve located a setup code that works for
your combo device (for example, a TV/VCR
Combo) and a separate TV code is also listed,
you’ll need to program this code into the
remote control to access volume c ontrol (see
“Programming Device Control” starting on
page10).
5. For future reference, write down each working
device code in the boxes below:
TV/VCR or TV/DVD Code
TV Code (if used)
SEARCHING FOR YOUR CODE
If your home entertainment device does not respond to
the Atlas OCAP 5-Device Remote Control with Learning
after trying all of the codes listed for your brand, or if
your brand is not listed at all, try searching for your
code.
For example, to search for a code for your TV:
1. Turn on your TV.
4. Aim the remote control at your combo device
(for example, TV/VCR Combo) and press
PWR once. The device should turn off. If it
does not respond, repeat steps 2 through 3,
trying each code listed for your brand until
you find one that works. If it still does not
respond, try searching for the code
(“Searching for Your Code” starting on
page13).
2. On the remote control, press TV once; it will
blink once. Then press and hold SETUP until
the TV key blinks twice.