Universal Electronics CABLE 4 manual Changing Volume Lock

Atlas Manual rev2 12/27/02 11:08 AM Page 28

CHANGING VOLUME LOCK

On the Atlas Universal Remote Control, Global Volume Lock is set to TV, so you can control TV volume while in the TV, VCR, or Cable mode. If desired, you can still perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

NOTE: If you lock the volume controls to the AUDIO mode, you will still have control of the audio device’s volume in all other modes (i.e., TV, VCR, and CBL).

To Unlock Volume Control For A Single Device (Individual Volume Unlock):

1. Assuming Global Volume Lock is active, select a mode on the remote control that you want to unlock (e.g.,CBL) and press it once. Next, press and hold SETUP until the device key blinks twice, then release SETUP.

2. Enter 9 - 9 - 3. The last-selected device key will blink twice.

3. Press VOL– once. The selected device key will blink four times.

4.Repeat steps 1 through 3 (of this section) for each device you want volume to be unlocked.

5.Now, after you select a device that has volume unlocked (e.g., CBL), pressing VOL+, VOL–, or MUTE, will control the device’s volume only in its own mode.

To Unlock All Volume Control

(Global Volume Unlock):

NOTE: Performing these instructions will set independent volume control for all programmed devices (e.g., TV volume control in TV mode, VCR volume in VCR mode, etc.).

1.On the remote control, press and hold SETUP until the last-selected device key blinks twice, then release SETUP.

2. Enter 9 - 9 - 3. The last-selected device key will blink twice.

3. Press VOL+ once. The last-selected device key will blink four times.

28