Universal Electronics CABLE 4 manual Troubleshooting, Problem, Solution

Atlas Manual rev2 12/27/02 11:08 AM Page 30

TROUBLESHOOTING

PROBLEM:	Mode key does not blink when you press a key.
SOLUTION:	Replace the batteries with two (2) new AA
	alkaline batteries (see page 7).
PROBLEM:	Mode key blinks when you press a key, but home
	entertainment device does not respond.
SOLUTION:	Make sure you are aiming the remote control at
	your home entertainment device and that you
	are within 15 feet of the device you are trying
	to control.
PROBLEM:	The remote control does not control home
	entertainment devices or commands are not
	performing properly.
SOLUTION:	Try all listed codes for the device brand being set
	up. Make sure all devices can be operated with
	an infrared remote control.
PROBLEM:	TV/VCR combo does not respond properly.
SOLUTION:	Use the VCR codes for your brand. Some combo
	units may require both a TV code and a VCR
	code for full operation (see page 9).
PROBLEM:	No volume on a second TV.
SOLUTION:	Follow instructions in Changing Volume Lock
	(see page 28).
PROBLEM:	CH+ , CH – , and LAST do not work for your
	RCA TV.
SOLUTION:	Due to RCA design (1983-1987), only the original
	remote control will operate these functions.
PROBLEM:	Changing channels does not work properly.
SOLUTION:	If original remote control required pressing
	ENTER to change channels, press ENTER on the
	remote control after entering a channel number.
PROBLEM:	Tried “Search Method” and still could not find a
	working code.
SOLUTION:	Try the “Search Method” again after clearing out
	the device key as follows: Press and hold SETUP
	until mode key blinks twice, then release. Next
	enter 9 - 9 - 2. Then press and release the mode
	key to be cleared twice.
PROBLEM:	Remote control does not turn on Sony or Sharp
	TV/VCR Combo.
SOLUTION:	For power on, these products require program-
	ming TV codes on the remote control. For Sony,
	use TV code 0000 and VCR code 0032. For Sharp,
	use TV code 0093 and VCR code 0048.

30