23
PROGRAMMING CHANNEL CONTROL LOCK
By default,the remote control’s channel-control capabilities
are locked to the cable converter.The affected keys* are
0~9,CH+,CH-,ENTER,and LAST.This will guarantee that
you do not inadvertently change a channel on your TV or
VCR.However,you can de-activate this feature to allow full
access to these keys in the TV and VCR modes.
*NOTE:This feature does not affect the AUDmode.

To De-Activate Channel Control Lock:

1. On the remote control,press CBLonce.
Then press and hold SETUPuntil the
CBLkey blinks twice, then release SETUP.
2. Enter 9-7- 3.The CBLkey will blink two times.
3. Press CH-once. The CBL key will bli nk
four times.
4. Now,the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.

To Re-Activate Channel Control Lock:

1. On the remote control,press CBLonce.
Then press and hold SETUPuntil the
CBLkey blinks twice, then release SETUP.
2. Enter 9-7- 3.The CBLkey will blink two times.
3. Press CH+once. The CBL key will blink twice.
4. Now,regardless ofwhat mode you select
(i.e.,TV,VCR,or CBL),only the channel
control capability ofyour cable converter will
be accessible.
Atlas Manual rev2 12/27/02 11:07 AM Page 23