PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following instructions to control this device:
1.Turn on your TV/VCR Combo and insert a video cassette.
2. On the remote control, press VCR once. Press and hold SETUP until the VCR key blinks twice, then release SETUP.
3.Use the Setup Codes For TV/VCR Combos (on page 43) to locate the brand name and then enter the first
NOTE: If the VCR key did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.
If you’ve located a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see Programming Device Control on page 8).
4. Aim the remote control at your TV/VCR
Combo and press POWER once. The device
should turn off. If it does not respond, repeat steps 2 through 3, trying each code listed for your brand until you find one that works.
If it still does not respond, try searching for the code (see Searching For Your Code on the next page).
5.For future reference, write down each working device code in the boxes below:
TV/VCR Code
TV Code (if used)
10