Universal Remote Control DMS-AV TPS2000 Selecting the Surround mode, Cancelling the surround mode for stereo operation , Tone Setting

Page 40
DMS-AV HOME THEATER AMPLIFIER
Selecting the Surround mode
Before surround playback, first perform the speaker setup procedure, etc.
on the OSD settings for optimum performance.
Select the desired surround mode by pressing the SURROUND UP(•) /
DOWN(•) buttons.
•Each time the buttons are pressed, the surround mode changes
depending on the input signal format as the table below:
Depending on surround back speaker setting, some surround modes can be selected or not as follows
< > : possible only when surround back speaker is not set to “NO”.
[ ] : possible only when surround back speaker is set to “NO”.
( ) : possible only when surround back speaker is set to “2ch”.
{ } : possible only when front height speaker is set to “ON”.
* : stand for THEATER, MOVIE, HALL, GAME, STADIUM, MCH STEREO, F.S.S, A.L.C.
** : on the signal format being input, the Dolby Pro Logic IIx modes may not be selected.
Note
•When “Center” and “Surround” are set to “NO”, any surround mode cannot be selected and the source can
be reproduced in the stereo mode.
•While playing digital signals from Dolby Digital or Dolby TrueHD program source or listening in Dolby Pro
Logic II/Dolby Pro Logic IIx Music mode or Dolby Pro-Logic IIz mode, you can adjust their parameters for
optimum surround effect.
Cancelling the surround mode for stereo operation
Press the STEREO button.
Depending on the signal format which is being input, either the Stereo
Mode or the 2CH down-mix model is selected.
Tone Setting
Bass and Treble controls are available in the Tone Setting menu. These are
shelving tone controls, and allow the addition or subtraction of low or high
frequency content from the selected audio source.