DMS-AV HOME THEATER AMPLIFIER
Page 25
Configuration and Control - Hardware Connections
Ethernet Communication - Connection Instructions
1. Make sure that all devices are powered Off, including the DMS-AV, PCs,
routers, switches, etc.
2. Connect one end of an Ethernet network cable to one of the numbered
ports on the back of the router. Connect the other end to the Ethernet port
in the rear of the DMS-AV. Repeat this step to connect more PCs or other
network devices that require a wired connection to the router. Power the
router as needed.
3. Connect your cable or DSL modem’s Ethernet cable to the router’s Internet
port. Power On the cable or DSL modem, DMS-AV, router, etc.
4. Power On your PC(s).
Infrared Input
The DMS-AV allows for basic infrared control via the IR Input port. Connect
an Infrared receiver, such as a URC MRF-350 IR/RF Base Station to the
infrared input port on the back of the DMS-AV. The DMS-AV does not
support a built-in front panel infrared receiver. All connections are 3.5mm
(mono mini) jack, with the tip positive(+), and the sleeve being ground.
MRF-350 RF Base Station to DMS-AV IR Input